| Accessories
for your Universal Fret Slotter |
NEW! Motorised Attachment
Now Necx Products has developed a motorised option utilising
the Dremel Mini Saw Attachment.
Now cut slots in a fraction of the time!
|
Make your OWN Hole
Plates!
If you decide that you prefer to use a hole
plate system, accessories can be purchased to allow you
to drill your own custom hole plates.
This includes an accurate hardened steel
drill bush and screw that locate in the side of the carriage
block.
|
 |
Brass bar is screwed inside the channel
and drilled after accurately setting and locking the vernier
scale to the correct position.
 An
ordinary pistol drill is used, but the drill bush guide
is what gives the great accuracy. |
 |
The drill bush is then replaced by a highly
accurate locator pin.
 |
 |
Additional uses
The
Necx Fret Slotter can be used also to cut evenly spaced
linings for acoustic instruments. By drilling two holes
in the side of your own tenon saw, the brass slides
attached to the fret saw can be swapped to the tenon
saw so that wider slots can be cut. |
|
 |
